White 4075 Manuale delle Istruzioni

Excalibur Water Systems142 Commerce Park Drive, Unit M & NBarrie, Ontario L4N 8W8 CANADAwww.excaliburwater.com REVERSE OSMOSISWATER FILTRATION

STEP EIGHT – SANITIZE, TEST & PURGESanitizeNote: Sanitization is recommended immediately after RO Filter System installation and anyinner-part se

Filter Replacement1 Close angle valve located on cold water supply hose to shut off watersupply to the RO Filter System.2 Turn cartridge from right to

4STAGE RO SYSTEM  MODEL EWR 4075U.S. MetricMembrane Production1 75 ± 7 gpd (283 ± 26 lpd)Membrane TDS Reduction1 96.6% minimum 96.6% minimumSystem P

Non-potable Water Sources: Do not attempt to use this product to make safe drinking water from non-potable water sources. Do not usethe system on micr

SYSTEM MAINTENANCEPrelter/PostlterThe pre-lters (sediment- stage 1 and carbon - stage 2) and post-lter (carbon - stage 4) are replaceablecartridg

Pre-Filter & Post-Filter Cartridge Replacement1 Remove pre-lter cartridge by turning to the left.2 Remove post-lter cartridge by turning to the

Excalibur Water Systems142 Commerce Park Drive, Unit M & NBarrie, Ontario L4N 8W8 CANADAwww.excaliburwater.com

6’ of 1/4” White TubeUTeflon® TapeTank ValveAngle ValveAdapterSedimentCartridgeSCarbonCartridgeCReverse OsmosisMembraneROCarbonCartridgeCFaucet Adapter

PLAN FOR INSTALLATIONPrior to installation, we recommend you read the entire manual. This will not only familiarize you with thesystem, but it will h

AngleValve AdapterREMOTE INSTALLATION(requires nearby water source and drain)STEP ONE – INSTALL ANGLE VALVE ADAPTER1 Identify the cold water line in t

STEP TWO – INSTALL RO DRAIN CONNECTOR1 Identify drain outlet location.2 From back of foam seal, remove protective cover.3 Knock center hole out, align

H Teflon® TapeTank ValveSTEP FOUR – INSTALL WATER STORAGE TANK1 On the nipple on top of the tank, apply 2-3 wraps of Teon® tape.2 Hand-tighten the

STEP SIX – CONNECT TUBINGInstall tubing for water supply line fromangle valve adapter to manifold inlet.Note: Do not bend or crimp tubing during this

STEP SIX – CONNECT TUBING (Continued)Drain tting to Restrictor.1 Locate membrane drain port on lower membrane side.2 By pushing down on the white col

NOTE: THIS STEP FOR REMOTE LOCATIONS ONLYSTEP SEVEN – INSTALL RO SYSTEM & DRAIN1 Determine if tubing is long enough to reach drain. If yes, inse